The Outfitter™ Series ZU -06 to -12 R-410A Rooftop Single Package Air Conditioners & Gas/Electric Heat Units
The ZU 6.5 – 12.5 ton product line reaches up to 11.7 EER. Flexible, single-package models in cooling and electric/gas heat configurations, with side and down airflow convertibility. A common footprint allows easy installation on a curb, slab, roof rack, or frame. Every unit is completely charged, wired, piped, and tested. Servicing is simple with a slide-out motor and blower. You’ll also discover foil-faced insulation for improved IAQ. Two compressors and independent refrigeration circuits ensure reliability.
Special Benefits:
● A single 42″ or 50 3/4″ H x 59″ W x 89″ D cabinet means simple installation regardless of unit tonnage.
● Specify units for cooling only, cooling with electric heat, and cooling with gas heat.
● Two-stage heat/two-stage cool provides ultimate comfort.
● Convertibility for side or down airflow discharge, with single-enthalpy economizers used on either application.
● Choose from a wide range of factory-installed options and standards like BAS controls, dirty filter and disconnect switches, barometric relief and power exhaust, phase monitors, smoke detectors, stainless steel heat exchangers, and much more.
● The dual-circuit reliability of two compressors with independent refrigeration circuits, electronic spark ignition, and power-vented combustion.
● Install these compact units almost anywhere there’s a curb, slab, roof rack, or frame.
● Each unit is completely charged with R-410a—wired, piped, and tested.
● All units are assembled and delivered on rigid, full-perimeter base rails, allowing for 3-way forklift access and overhead rigging.
● Tool-free maintenance with features like hinged doors for all-access panels, slide-out blower and blower motor tray, and self-tensioning blower belt.
● IAQ features like foil-faced insulation, pitched roof, and removable drain pan.
● Can be ordered practically ready for immediate installation.
Rugged reliability, efficiency, easy installation, trouble-free operation—it’s all packed into these compact Coleman® packaged units. For maximum flexibility, the convertible airflow design requires no panel cutting, and can handle most airflow requirements.
Gas and electric knockouts are supplied for easy access. And units can be specified for cooling only, cooling with electric heat, cooling with gas heat or cooling with a heat pump.
● Dual-stage cooling for maximum comfort (6.5–12.5 ton units)
● Simplicity® control board with screw connector for thermostat wiring
● Second model nameplate inside hinged access panel (standard on all light commercial products)
● Optional disconnect
● Base rails with forklift slots on three sides and lifting holes on each corner
● Optional powered or non-powered 120 volt GFI convenience outlet
● Common roof curb for all sizes
● Easy to clean and access condenser section
●Tool-free door latches
● Compressor #2 access (6.5–12.5 ton units)
● Slide-out motor and blower assembly for easy adjustment and service
● Belt-drive blower motor
● Slide-out filter access offering 2” or 4” filters
● Solid-core filter drier
● Hinged compressor #1 and/or #2 access
● Removable and reversible drain pan
● Bottom- and side-entry power and control wiring knockouts
● Single- or two-stage heating available on 3–5 ton models
● Two-stage gas heating operation standard on 6.5–12.5 ton models
Available models for Outfitter™ Series ZU -06 to -12 R-410A Rooftop Single Package Air Conditioners & Gas/Electric Heat Units-
1) Outfitter™ Cooling Only Mid-Efficiency Rooftop Packaged Units (ZU): ZU-06C00, ZU-07C00, ZU-08C00, ZU-10C00 and ZU-12C00.
2) Outfitter™ Electric/Electric Mid-Efficiency Rooftop Packaged Units (ZU): ZU-06E, ZU-07E, ZU-08E, ZU-10E and ZU-12E.
3) Outfitter™ Gas/Electric Mid-Efficiency Rooftop Packaged Units (ZU): ZU-06N12, ZU-06N18, ZU-07N12, ZU-07N18, ZU-08N12, ZU-08N18, ZU-10N18, ZU-10N24, ZU-12N18 and ZU-12N24.