The Outfitter™ Series ZU-A3, -A4,- A5 R-410A Rooftop Single Package Air Conditioners & Gas/Electric Heat Units
The ZU-A3, -A4,- A5 Outfitter R-410A Packaged Unit.The next advancement in the packaged product line is here. The new Outfitter 3, 4 & 5 ton line reaches up to 14 SEER and 11.8 EER. Flexible, single-package models in cooling and electric/gas heat configurations, with side and down airflow convertibility. A common footprint allows easy installation on a curb, slab, roof rack, or frame. Every unit is completely charged, wired, piped, and tested. Servicing is simple with a slide-out motor and blower.The product includes foil-faced insulation for improved IAQ..

Special Benefits:
● A single 42″ H x 59″ W x 89″ D cabinet means simple installation regardless of unit tonnage.
● Specify units for cooling only, cooling with electric heat, and cooling with gas heat.
● A single or two-stage heat option provides ultimate comfort.
● Convertibility for side or down airflow discharge, with single-enthalpy economizers used on either application.
● Choose from a wide range of factory-installed options and standards like BAS controls, dirty filter and disconnect switches, barometric relief and power exhaust, phase monitors, smoke detectors, stainless steel heat exchangers, and much more.
● Install these compact units almost anywhere there on a curb, slab, roof rack, or frame.
● Each unit is completely charged with R-410A,wired, piped, and tested.
● All units are assembled and delivered on rigid, full-perimeter base rails, allowing for 3-way forklift access and overhead rigging.
● Tool-free maintenance with features like hinged doors for all-access panels, slide-out blower and blower motor tray.
● IAQ features like foil-faced insulation, pitched roof, and removable drain pan.
● Can be ordered practically ready for immediate installation.

Rugged reliability, efficiency, easy installation, trouble-free operation—it’s all packed
into these compact Coleman® packaged units. For maximum flexibility, the convertible
airflow design requires no panel cutting, and can handle most airflow requirements.
Gas and electric knockouts are supplied for easy access. And units can be specified for
cooling only, cooling with electric heat, cooling with gas heat or cooling with a heat pump.

● Dual-stage cooling for maximum comfort (6.5–12.5 ton units)
● Simplicity® control board with screw connector for thermostat wiring
● Second model nameplate inside hinged access panel (standard on all light commercial products)
● Optional disconnect
● Base rails with forklift slots on three sides and lifting holes on each corner
● Optional powered or non-powered 120 volt GFI convenience outlet
● Common roof curb for all sizes
● Easy to clean and access condenser section
●Tool-free door latches
● Compressor #2 access (6.5–12.5 ton units)
● Slide-out motor and blower assembly for easy adjustment and service
● Belt-drive blower motor
● Slide-out filter access offering 2” or 4” filters
● Solid-core filter drier
● Hinged compressor #1 and/or #2 access
● Removable and reversible drain pan
● Bottom- and side-entry power and control wiring knockouts
● Single- or two-stage heating available on 3–5 ton models
● Two-stage gas heating operation standard on 6.5–12.5 ton models

Outfitter™ Series ZU-A3, -A4,- A5 R-410A Rooftop Single Package Air Conditioners & Gas/Electric Heat Units-
1) Outfitter™ Cooling Only Mid-Efficiency Rooftop Packaged Units (ZU): ZU-A3C00*, ZU-A4C00* and ZU-A5C00*.

2) Outfitter™ Electric/Electric Mid-Efficiency Rooftop Packaged Units (ZU): ZU-A3E*, ZU-A4E* and ZU-A5E*.

3) Outfitter™ Gas/Electric Mid-Efficiency Rooftop Packaged Units (ZU): ZU-A3N06*, ZU-A3N08*, ZU-A3N11*, ZU-A4N06*, ZU-A4N08*, ZU-A4N11*, ZU-A5N08*, ZU-A5N11* and ZU-A5N16*.

Note:
*ZU-A3, -A4 and -A5 models are 14 SEER
ZU gas/electric models are ENERGY STAR® qualified.