The Outfitter™ Series XA -06 to -12 R-410A Rooftops Single Packaged Heat Pumps
The Coleman XA series offers flexible, single-package models with side and down airflow convertibility. A common footprint allows easy installation on a curb, slab, roof rack, or frame. Every unit is completely charged, wired, piped, and tested. Servicing is simple with a slide-out motor and blower. You’ll also discover foil-faced insulation for improved IAQ. Two compressors and independent refrigeration circuits ensure reliability on 7.5, 8.5, 10 and 12.5 Ton models.
Special Benefits:
● Two cabinet heights (42″ & 50 3/4″) and a common 50-1/2″ W x 80-5/8″ D footprint means simple installation.
● Convertibility for side or down airflow discharge, with single-enthalpy economizers used on either application.
● Choose from a wide range of factory-installed options and standards like dirty filter switch, disconnect switch, barometric relief and power exhaust, phase monitors, smoke detectors, and much more.
● Dual-circuit reliability of two compressors with independent refrigeration circuits on 7.5, 8.5, 10 and 12.5 Ton models.
Install these compact units almost anywhere there’s a curb, slab, roof rack, or frame.
● Each unit is completely charged with R-410A—wired, piped, and tested.
● All units are assembled and delivered on rigid, full-perimeter base rails, allowing for 3-way forklift access and overhead rigging.
● Tool-free maintenance with features like hinged doors for all-access panels and slide-out blower and blower motor tray.
● IAQ features like foil-faced insulation, pitched roof, and removable drain pan.
● Can be ordered practically ready for immediate installation.
Rugged reliability, efficiency, easy installation, trouble-free operation—it’s all packed
into these compact Coleman® packaged units. For maximum flexibility, the convertible
airflow design requires no panel cutting, and can handle most airflow requirements.
Gas and electric knockouts are supplied for easy access. And units can be specified for
cooling only, cooling with electric heat, cooling with gas heat or cooling with a heat pump.
● Dual-stage cooling for maximum comfort (6.5–12.5 ton units)
● Simplicity® control board with screw connector for thermostat wiring
● Second model nameplate inside hinged access panel (standard on all light commercial products)
● Optional disconnect
● Base rails with forklift slots on three sides and lifting holes on each corner
● Optional powered or non-powered 120 volt GFI convenience outlet
● Common roof curb for all sizes
● Easy to clean and access condenser section
● Tool-free door latches Compressor #2 access (6.5–12.5 ton units)
● Slide-out motor and blower assembly for easy adjustment and service
● Belt-drive blower motor
● Slide-out filter access offering 2” or 4” filters
● Solid-core filter drier
● Hinged compressor #1 and/or #2 access
● Removable and reversible drain pan
● Bottom- and side-entry power and control wiring knockouts
● Single- or two-stage heating available on 3–5 ton models
● Two-stage gas heating operation standard on 6.5–12.5 ton models
Available models for Outfitter™ Series XA -06 to -12 R-410A Rooftops Single Packaged Heat Pumps: XA-06C00, XA-06E, XA-07C00, XA-07E, XA-08C00, XA-08E, XA-10C00, XA-10E, XA-12C00 and XA-12E.